Connect the prepared fuel hose [A] to the fuel outlet pipe.
Secure the fuel hose with a clamp.
Insert the fuel hose into the measuring cylinder [B].
Wipe off spilled out fuel immediately.
Be sure to hold the measuring cylinder vertical.
Close the fuel tank cap.
Turn the engine stop switch to run position.
Turn the ignition switch ON.
The fuel pump should operate for 3 seconds, and then
Do not drive the fuel pump 3 seconds or more with-
out the fuel in the fuel tank. If the fuel pump is driven
without the fuel, it may be damaged.
Measure the discharge for 3 seconds.
Repeat this operation several times.
Amount of Fuel Flow
29 mL (0.98 US oz.) or more for 3 seconds
Turn the ignition switch OFF.
If the fuel flow is much less than the specified, replace the
fuel pump (see Fuel Pump Removal/Installation).
Install the fuel tank (see Fuel Tank Installation).
Start the engine and check for fuel leakage.
FUEL SYSTEM (DFI) 3-91