Craftsman sears 315.277170 Owner's Manual page 8

DUSTLESS SANDING
The dust box located on the rear of your sander provides a
dust collection system for your sander. Sanding dust is drawn
up through the holes of the sanding disc to collect in the dust
box during sanding operation. For more efficient operation,
empty dust box when half full.
REMOVING DUST BOX
See Figure 7.
1. To release dust box, depress tabs located on each side of
dust box.
2. Slide dust box down and lift from sander as shown by the
arrows in figure 7.
3. DO NOT press on the filter material with your hand or
fingers. Filter material can be damaged.
NOTE: Filter material is located on the sides of dust box.
4. DO NOT break tabs that secure dust box to sander.
5. Empty dust box.
TO INSTALL DUST BOX
See Figure 8.
1. Realign dust box with rear of sander.
2. Slide dust box on sander as shown in figure 8. You will feel
a soft click as the tab snaps into place.
NOTE: As mentioned above, be careful not to break the
tabs that secure dust box to sander.
WARNING:
Do not use this product as a component of other products.
Also, do not use attachments or accessories not
recommended for use with this product. Any such use
could result in possible serious personal injury.
REMOVE SANDING DISC BEFORE STORAGE
Do not store your sander with a sanding disc installed. Heat
generated from sanding causes the pressure sensitive
adhesive to flow and form a tight bond between the backing
pad and sanding disc.
Removing the sanding disc soon after you have finished a
sanding operation avoids letting the adhesive set up. If the
sanding disc is left on the backing pad for an extened period
of time after use, the adhesive will set up and cause the
sanding disc to become difficult to remove. It may also tear
when removing. When this situation occurs, it becomes
difficult to clean the backing pad for the next sanding disc.
NOTE: If you forget to remove the sanding disc after a
sanding operation, sand for a few minutes to soften the
adhesive backing before attempting to remove sanding disc.
OPERATION
TABS
Page 8
TABS
TO REMOVE
TO INSTALL
DUST BOX
TABS
Fig. 7
Fig. 8