Detergent Dispenser; Rinse Aid Dispenser; Amount Of Detergent To Use; Proper Use Of Detergent - Kenwood KDW243A Instruction Manual

Table of Contents

Advertisement

YOU MAY NOT NEED TO ADD TOO MUCH DETERGENT BECAUSE YOUR DISHWASHER HAS A SPECIALLY-DESIGNED WATER
SOFTENER.
The dispenser must be refilled before the start of each wash cycle following the instructions provided i n the" Wash Cycle
Table". Generally, only one tablespoon of detergent is needed for a normal wash load. Also, more heavily soiled items need
more detergent. Always add the detergent just before starting dishwasher, otherwise it could get damp and will not dissolve
properly.
The amount of detergent needed can vary due to differences in water hardness. To determine the water hardness in your area,
contact your local water utility. The harder the water, the more detergent you may need.
Remember, you should adjust the amount of detergent you use by small amounts until you find the correct amount.
To open the dispenser, turn the cap to the "open" (left)
arrow and lift it out.
Pour the rinse aid into the dispenser, being careful not to
overfill.
Replace the cap by inserting it aligned with "open" arrow
and turning it to the closed (right) arrow.
Use only detergent specifically made for use in dishwashers.
Keep your detergent fresh and dry. Don't put powder detergent
into the dispenser until you're ready to wash dishes.
Dishwasher detergent is corrosive! Take care to keep it out
of reach of children.
A measured amount of rinse aid is released during the final rinse. As with detergent, the amount
of rinse aid needed for your dishes depends on the hardness of the water in your area. Too much
rinse aid can result in lather of foaming and cause cloudiness or steaks on your dishes. If the
water in your area is very soft, you may not need rinse aid. If you do,you can dilute the rinse aid
with an equal amount of water.
The rinse aid dispenser has six settings. Always start with the dispenser set on " 1 ". If spots and
poor drying are problems, increase the amount of rinse aid dispensed by removing the dispenser
lid and rotating the dial to "2". If the dishes stil l are not drying properly or are spotted, adjust the
dial to the next higher number until your dishes are spot-free.
The rinse aid is released during the final rinse to prevent water
from forming droplets on your dishes that can leave spots and
streaks. It also improves drying by allowing water to "sheet" off
the dishes.
Your dishwashers are designed to use liquid rinse aids. The
rinse aid dispenser is located inside the door next to the
detergent dispenser. To fill the dispenser, open the cap and
pour the rinse aid into the dispenser until the level indicator
turns completely black. The dispenser holds about 100 ml of
liquid rinse aid.
Be careful not to overfill the dispenser, because this could
cause oversudsing. Wipe away any spills with a damp cloth.
Don't forget to replace the cap before you close the dishwasher
door.
If you have soft water, you may not need rinse aid for it may
cause a white film to develop on your dishes.
5

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents