Electrical Connection - Hotpoint CID740B Instructions For Use Manual

ELECTRICAL CONNECTION

WARNING
- The manufacturer declines all liability for injury to persons or animals and for damage to property resulting from failure to observe the regulations
provided in this chapter.
- The power cable must be long enough to allow the hob to be removed from the worktop.
- Make sure the voltage specified on the dataplate located on the bottom of the appliance is the same as that of the home.
1. Remove the terminal cover (A) by unscrewing the screw and insert the cover into the hinge (B) of the terminal.
2. Plug the power cord into the clamp and connect the wires to the terminal block as shown in the wiring diagram located near the terminal.
3. Secure the power cable with the cable clamp.
4. Close the cover (C) and screw on the terminal with the screw removed.
For each connection to the network, the hob automatically checks for a few seconds.
black
brown
blue
}
blue (grey)
yellow/green
- Disconnect the appliance from the power supply.
- Installation must be carried out by qualified personnel who know the current safety and
installation regulations.
AU and UK
black
}
brown
yellow/green
blue
}
blue (grey)
ONLY FOR BELGIUM
black
brown
blue
}
blue (grey)
yellow/green
EN8
blue/grey
black/brown
yellow/green
Connection to main power
230V 2 phase 2N
ONLY FOR NL
black
brown
yellow/green
blue
blue (grey)