Rack Mounting; Battery Insertion Of The Transmitter - JTS US-8001D Instruction Manual

5-2 Rack Mounting

(1) Before mount receivers onto DR-900 rack adaptor, please release any cables from the rear of
the receiver.
(2) Turn over receiver and DR-900 rack adaptor simultaneously, there are 4 threaded holes each
in the bottom of receiver and rack adaptor for inserting screws.
(3) Single receiver
Insert in a receiver through the front of DR-900 until it is firmly attached to the rack, then
screw on a RP-900 to another side of the rack. (Figure 4)
(4) Dual receivers
The same way as above, put one receiver to each rack space.
(Figure 4)
13 WIRELESS MICROPHONE SYSTEM

5-3 Battery Insertion of the transmitter

(1) Mh-850 & Mh-750 Handheld Transmitter
1. Turn the microphone ball grille counter-clockwise
( Figure 1), press both release knobs to remove the
battery tray from the mic. housing ( Figure 2).
2. Insert two 1.5V batteries according to the correct polarity
(Step 1 of Figure 3) and return the battery tray back to
housing (Step 2 of Figure 3).
Aim the connecting pins exactly toward the cavities on the
bottom side of detachable mic. capsule module ( Figure 4)
and tighten it clockwise!
Figure 1 Figure 2
(2) Mh-8016 Series Handheld Transmitter
1. Insert 2 pcs 1.5V AA batteries into the battery tray.
2. After putting into the battery, switch on the power switch.
1
2
Figure 3 Figure 4
14