Download  Print this page

En18; Overload Protection; Replacement Parts; Specifications - Panasonic MJ-L500 Operating Instructions Manual

Hide thumbs

Advertisement

Problem
Is the power plug inserted into an outlet?
Insert the power plug into an outlet.
The lid needs to be turned until you hear a "click" sound. If you
fail to do so, the juicer will not run after the power is switched
The juicer does not
on. (P. EN12)
run after the power is
The overload protection is activated.
switched on.
See "Overload protection" (P. EN19).
Remove prohibited ingredients from the juicer.
The operating time is longer than the rated duration.
Follow the rated duration (up to 15 minutes).
The motor housing is hot.
To resume operation, please wait for at least 30 minutes. This
allows the motor housing to cool down and avoid failure due to
overheating of motor.
The lid is open.
Switch off the power, close the lid, and start again.
The overload protection is activated.
The juicer stopped
suddenly.
See "Overload protection" (P. EN19).
Remove prohibited ingredients from the juicer.
Clogging of pulp spout.
Switch off the power and remove residue using the tip of
the cleaning brush handle.
This is normal.
You may hear sound such as squeaking or cracking.
Noise during operation.
These are the sound of ingredients being compressed.
(Depending on the ingredients, the noise may be quite loud.)
This is the sound of the rotating brush contacting with filter.
The rubber, rubber brushes and/or rubber plug are not
Leakage of juice or
assembled correctly.
frozen dish.
Assemble them correctly. (P. EN10,11,17)
This is normal.
The juicing bowl or motor
Since the juicing bowl and motor housing are split type, they
housing shakes during
may shake when the squeezing screw is rotating.
Do not press the lid or juicing bowl. (Doing so may result in
operation.
failure of the juicer.)
Abnormal noise or
The squeezing screw and attachments are not assembled correctly.
vibration.
Assemble the squeezing screw and attachments correctly (P. EN10,11).

EN18

Please check the following before contacting
us for repair.
Cause and solution

Overload protection

The motor may stop running when the internal overload protection is activated to prevent overload of motor.
If the motor stops, please take the following steps:
1
Press the "O" (OFF) button.
2
If the squeezing screw fails to run after reverse operation, then it means overheat protection is
activated. In this case, please unplug the power plug and leave the juicer to cool down for at
least 30 minutes.
3
4
Reduce the amount of ingredients being fed in and push them gently into feeding tube.

Replacement Parts

■ Filter
■ Gasket
Part number:
Part number:
AJD33-153-K0
AJD27-153
■ Pulp container
■ Rotating brush
Part number:
Part number:
AJD36-153-K1
AJD35-153-K0
■ Juice container
Part number:
AJD05-153-K1
Specifications
Power supply
Power consumption
18.5 × 17.6 × 43.2 cm (7.3 × 6.9 × 17.0 inches)
ON
OFF
REVERSE
■ Frozen attachment
Part number:
AJD38-153-A0
■ Rubber brush
Part number:
AJD34-153
MJ-L500
120 V
60 Hz
150 W
4.0 kg (8.8 lb)
1.0 m (39.4 inches)
EN19

Advertisement

Table of Contents
loading

  Related Manuals for Panasonic MJ-L500