Parent Unit Power Supply - Motorola MBP15 User Manual

2. Using a screwdriver, turn the screw on the back of the parent unit 90
degrees in a counterclockwise direction. Remove the battery cover.
NOTE
Do not try to rotate the screw further than the position
3. Install the enclosed 2 AAA rechargeable batteries following the
polarity as shown.
WARNING
Do not use non-rechargeable batteries for the Parent Unit. Risk of
explosion if battery is replaced by an incorrect type. Dispose of used
batteries according to the instructions.
4. Close the battery compartment and tighten the screw in a clockwise
direction.
P
5. Press . The LCD display will illuminate.
6. Press and hold
NOTE
When the battery level is low, the
display and the parent unit emits a short warning tone once every minute.
2.4

Parent unit power supply

1. Connect the power adapter cable of the charger pod to the mains
socket (230V/50Hz).
NOTE
Only use the enclosed adapter (6V DC / 300mA).
Getting started
P
to switch off the parent unit.
OPEN
icon will appear on the LCD
.
9