Led Worklight - Craftsman 5727.1 Operator's Manual

C3 1/4"
Hide thumbs Also See for 5727.1:
Table of Contents

Advertisement

Available languages

Available languages

LED WORKLIGHT
(Fig. 5)
The LED worklight,
located on
the base of the impact driver,
will illuminate when the trigger
switch
is depressed.
This provides
additional
light on the surface of
the workpiece.
The LED worklight
will turn off when the trigger
switch
is released.
BIT STORAGE
(Fig. 6)
When not in use, the bit can be
placed in the storage area located
on the base of the impact
driver.
Store the bit on the base of the
driver by snapping
it into place in
the bit clip.
INSTALLING
BITS (Fig. 7)
1.
Remove the battery
pack
from the impact driver when
installing the bit.
2.
Lock the trigger switch on the
impact driver by placing the
direction-of-rotation
(forward/
center-lock/reverse)
selector
in the center position.
3.
Pull the coupler away from
the driver.
4.
Insert the driver bit into
the coupler.
5.
Release the coupler.
6.
Pull on the bit to make sure
it is secured
in the coupler.
There may be some play in
the installed
bit; this is normal.
Fig.
LED Worklight
Fig. 6
____
Bit Clip
Fig. 7
Release
Pull
i
,_
WARNING:
Make sure the bit is secured
in the coupler
before using the
impact driver. If the coupler
does not return to its original position, the bit is not
correctly
installed.
Retry until the bit is properly
installed and the coupler
returns
to its original position.
Failure to do so could result in serious personal injury.
13

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents