Motorola HDT100 User Manual page 3

IMPORTANT SAFETY INSTRUCTIONS
1 3
Outdoor Antenna Grounding
If an outside antenna or cable system is connected to the equipment, be sure the antenna or cable
system is grounded as to provide some protection against voltage surges and built-up static
charges. Article 810 of the National Electrical Code, ANSI/NFPA 70, provides information with
regard to proper grounding of the mast and supporting structure, grounding of the lead-in wire to
an antenna discharge unit, size of grounding conductors, location of antenna-discharge unit,
connection to grounding electrodes, and requirements for the grounding electrode.
1 4
Lightning
For added protection for this equipment during a lightning storm, or when it is left unattended and
unused for long periods of time, unplug it from the wall outlet and disconnect the antenna or cable
system. This will prevent damage to the video product due to lightning and power line surges.
1 5
Power lines
An outside antenna system should not be located in the vicinity of overhead power lines or where it
can fall into such power lines or circuits. When installing an outside antenna system, extreme care
should be taken to keep from touching such power lines or circuits, as contact with them may be
fatal.
1 6
Overloading
Do not overload wall outlets and extension cords as this can result in a risk of fire or electrical
shock.
1 7
Object and liquid entry
Never push objects of any kind into this equipment through openings, as they may touch
dangerous voltage points or short-out parts that could result in a fire or electrical shock. Never spill
liquid of any kind on the product.
1 8
Servicing
Do not attempt to service this equipment yourself, as opening or removing covers may expose you
to dangerous voltage or other hazards, refer all servicing to qualified service personnel.
1 9
Damage requiring service
Unplug this equipment from the wall outlet and refer servicing to qualified service personnel under
the following conditions:
~=
When the power supply cord or plug is damaged.
Ä=
If the equipment has been exposed to rain or water.
Å=
If liquid has been spilled, or objects have fallen into the equipment.
Ç=
If the equipment does not operate normally by following the operating instructions. Adjust only
those controls that are covered by the operating instructions, as an improper adjustment of
other controls may result in damage and will often require extensive work by a qualified
technician to restore the equipment to its normal operation.
É=
If the equipment has been dropped or cabinet has been damaged.
Ñ=
When the equipment exhibits a distinct change in performance, indicating a need for service.
2 0
Replacement parts
When replacement parts are required, be sure the service technician has used replacement parts
specified by the manufacturer or have the same characteristics as the original part. Unauthorized
substitutions may result in fire, electric shock, or other hazards.
2 1
Safety check
Upon completion of any service or repairs to this video product, ask the service technician to
perform safety checks to determine that the product is in proper operational condition.