Introduction; Tools Needed For Installation; Materials You Will Need; Accessory Parts Supplied - Bosch SHU 6800 Installation Instructions Manual
Hide thumbs
Also See for SHU 6800:
- Use and care manual (32 pages) ,
- Installation instructions manual (19 pages) ,
- Use & care manual (16 pages)
Table of Contents
Advertisement
2
Introduction
Please read these installation instructions
completely
and carefully. They will save you time and effort and
help to ensure optimum dishwasher performance.
Be
sure to observe all listed warnings and cautions.
These installation
instructions are intended
for use by
qualified installers.
In addition
to these instructions
the
dishwasher
shall be installed:
*
In the United States, in accordance
with the
National
Electric
Code/State
and Municipal
codes
and/or local codes.
•
In Canada,
in accordance
with the Canadian
Electric
Code C22.1 - latest edition/Provincial
and
Municipal
codes and/or local codes.
These shall be carefully
followed
at all times.
If the dishwasher
is a new installation
most of the work
must be done before the dishwasher
is moved into place.
If the dishwasher
is replacing
another dishwasher
the
connections
for the dishwasher
being replaced
must be
checked
for compatibility
with the new dishwasher
and
replaced
as necessary.
Tools Needed
for Installation
Refer to Figure 1:
A. Tape Measure
B.
Flat blade screwdriver
C. Phillips screwdriver
D. Torx screwdriver, #20
E.
Electric
Drill
E
Hole saw or 1" hole cutter
G.
Hammer
H. Level
I.
Open end wrench
J.
Adjustable
wrench,
2 reqd.
K. Pipe wrench, 2 reqd.
L.
Wire Cutter
M. Wire stripper
Materials
You Will Need
•
Minimum
3/8" O.D. copper
tubing of sufficient
length for your installation.
•
Shut-off valve and fittings for hot water supply line.
•
90 ° elbow with 3/8" N.P.T. external threads on one
end and sized to fit your water supply line on the
other end.
•
Teflon tape or other pipe sealant.
•
3 twist-on wire connectors
for 16 AWG wire.
•
UL listed conduit connector or strain relief.
Additional materials may be required to comply with
local codes.
O
)
Figure
1.
Accessory
Parts Supplied
Check to make sure that the accessory
parts supplied
for
your model, see Figure 2, are all there. If any parts are
missing contact your dealer immediately.
Refer to Figure 2:
O. Cover Plugs (2)
E
Screws (2), for terminal
box cover/toe
panel
R.
Mounting
brackets
(2)
S.
Wood screws (2)
T.
Drain hose clamps (2) with rubber connection
hose (1)
U. Screws,
M6 x 26 (2)
V. Mounting
brackets
(4) and screws (8)
W. Template
sheet with instruction
pictograms.
X. Screws,
M4 x 42 (2) (SHV models only)
Y. Handle Installation
Kit with Instructions
(SHU 9900
models only)
Accessory parts supplied with:
SHU models
SHI and SHV models
_-C_
_
O__
0-44
Figure 2.
Hide quick links:
Advertisement
Table of Contents
