Removing The Display Assembly - Dell Precision M6500 Service Manual

Back to Contents Page
Display Assembly
Dell Precision™ Workstation M6500 Service Manual
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
Removing the Display Assembly
Replacing the Display Assembly
Removing the Display Bezel
Replacing the Display Bezel
Removing the Display Panel
Replacing the Display Panel
Removing the Display Assembly
NOTE: You may need to install Adobe® Flash® Player from Adobe.com in order to view the illustrations below.
1. Follow the procedures in Before Working Inside Your
2. Remove the battery.
3. Remove the access panel.
4. Remove the hinge cover.
5. Remove the keyboard.
6. Disconnect the wireless antenna cables from the wireless cards.
7. Remove the wireless antenna cables from their routing guides.
8. Remove the four screws that secure the display assembly to the computer.
9. Turn over the computer and open the display.
10. Disconnect the two display cables from the connectors on the system board.
11. Remove the screw that secures the display assembly to the computer.
12. Loosen the captive screw and remove the cable retention bar that secures the display assembly to the computer.
13. Disconnect the display cable from the connector on the computer.
14. Remove the antenna cables from their routing guides.
15. Remove the screws that secure the display assembly to the computer.
16. Remove the display assembly from the computer.
Computer.