Advanced New Message Alerting Features - Panasonic KX-TGE260 Operating Instructions Manual

Answering System for Landline
Key Operation
8 Turn answering system on
MPAUSEN
Pause message
9 or Stop recording
MSTOPN Stop playback
0 Turn answering system off
Erase currently playing
*4 *3
message
*5 Erase all messages
*6 Reset to a pre-recorded
greeting message
*1 If pressed within the first 5 seconds of a
message, the previous message is
played.
*2 To resume playback:
MbN: "Playback" a MSELECTN
*3 You can also erase as follows:
MPAUSEN a MbN: "Erase" a
MSELECTN a MbN: "Yes" a MSELECTN
Calling back (Caller ID subscribers
only)
n Using a cellular line:
1
Press MPAUSEN during playback.
2
MbN: "Call back (Cell)" a
MSELECTN
R The unit starts dialing when:
– only 1 cellular phone is paired.
– a specific line is set to make
cellular calls (page 21).
3
MbN: Select the desired cellular phone.
a MSELECTN
n Using the landline:
1
Press MPAUSEN during playback.
2
MbN: "Call back" a MSELECTN
Editing the number before calling back
1
Press MPAUSEN during playback.
2
MbN: "Edit & Call" a MSELECTN
For assistance, please visit http://www.panasonic.com/help
58
TGE26x_27x(en)_0123_ver110.pdf
3
*2
Erasing all messages
1
2
Advanced new message
alerting features
Audible message alert
This feature allows the base unit to beep to
inform you of a new message arrival when
new messages are recorded. The base unit
beeps 2 times every minute until you listen to
the messages, if the "Base unit beep"
setting is turned on. The default setting is
"Off".
1
2
New message alert by a call
This feature allows you to receive a
notification by phone when new messages are
recorded. The base unit calls a phone number
you specify. You can then operate the
answering system remotely to listen to the
new message.
To use this feature, you must:
– store a phone number to which the unit
makes the call to.
– turn on the new message alert setting.
After you answer the new message alert call,
you can listen to messages from that call
(page 59).
Important:
R A new message alert is stopped 1 minute
after the unit starts to call. The unit will not
retry the call even if the call is not answered.
58
Press MEDITN repeatedly until the phone
number is shown in the desired format
(page 50). a M N
R To call back using a cellular line,
continue from step 2, "Making cellular
calls", page 22.
MMENUN#325
MbN: "Yes" a MSELECTN a MOFFN
MMENUN#339
MbN: Select the desired setting. a
MSAVEN a MOFFN
2015/01/23 9:57:44