Troubleshooting (Before Calling For Service); Operating Range - Panasonic CS-ME7NKE Technical & Service Manual

Dc inverter multi-system air conditioner
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
How to install the air clean filter
The air clean filter needs to be installed behind the anti-mold filter.
Open the front panel and remove the anti-mold filters, then install
the air clean filter in the position shown in the figure. After that,
remount the anti-mold filters and close the front panel.
Air clean filter
How to clean the air clean filter
• In general, the filter should be sucked to remove dust in low fan
speed of a vacuum cleaner once every three months.
• If there is heavily grime on the filter, soak the filter in lukewarm
water with neutral detergent diluted 1:500 for 1 to 2 minutes then
wash it.
• Rinse the filter in clean water, then let it dry on the towel in room
temperature.
NOTE
• Do not bend nor give excessive force onto the air clean filter.
• If the filter surface is heavily blocked with dirt or damaged,
replace it with new one. Purchase a replacement filter at your
local dealer. (model CZ-SA1U)
Cleaning the main unit and remote controller
• Wipe clean using a soft, dry cloth.
• To remove stubborn dirt, moisten a cloth in warm water no hotter
than 40 °C, wring thoroughly, and then wipe.
• The front panel can be removed in order to wash it with water.
Removing and remounting the front panel
1.
Open the front panel until it is nearly horizontal, grasp the
sections near the front panel arms on both sides, and then pull
forward to remove the front panel.
2.
Grasp the sections near the front panel arms on both sides,
and hold the front panel so that it is nearly horizontal. Then
push firmly until the arm shafts click into place. After closing the
front panel, press firmly on the parts indicated by the arrows to
securely fasten the panel in place.
Also refer to the figure that shows "How to replace the anti-
mold filter".
When using a footstool or the like, be
CAUTION
careful not to let it tip over.
Washing the front panel with water
• Clean the front panel gently using a soft sponge, or the like.
Then wipe away any remaining moisture.
• Neutral detergent may be used to remove stubborn dirt. Then
rinse thoroughly with water and wipe away any remaining
moisture.
TROUBLESHOOTING (BEFORE
CALLING FOR SERVICE)
If your air conditioner does not work properly, first check the
following points before requesting service. If it still does not work
properly, contact your dealer or service center.
Trouble
Possible Cause
Air conditioner does
1. Power failure.
not run at all.
2. Leakage circuit
breaker tripped.
3. Line voltage is too
low.
4. Batteries in remote
controller have run
down.
OPERATION lamp
Trouble in system.
blinks and air
conditioner does not
operate.
Compressor runs but
Obstruction in front of
soon stops.
condenser coil.
Poor cooling (or
1. Dirty or clogged air
heating)
filter.
performance.
2. Heat source or
many people in
room.
3. Doors and/or
windows are open.
4. Obstacle near air
intake or air
discharge port.
5. Thermostat is set
too high for cooling
(or too low for
heating).
6. (Outdoor
temperature is too
low for heating.)
Clicking sound is
In heating or cooling
heard from the air
operation, any plastic
conditioner.
parts may expand or
shrink due to a
sudden temperature
change. In this event,
a clicking sound may
occur.
OPERATION lamp
The use of cellular
lights but outdoor unit
phones near the air
will not run.
conditioner may
cause disturbance to
its normal operation.

OPERATING RANGE

The air conditioner is operable within the temperature ranges as
listed below:
Temperature Indoor air
temperature
COOLING Max.
32 °C DB /
23 °C WB
Min.
19 °C DB /
14 °C WB
HEATING
Max.
27 °C DB
Min.
16 °C DB
Remedy
1. Restore power.
2. Contact service
center.
3. Consult your
electrician or
dealer.
4. Replace batteries.
Contact service
center.
Remove obstruction.
1. Clean air filter to
improve airflow.
2. Eliminate heat
source if possible.
3. Shut them to keep
the heat (or cold)
out.
4. Remove it to
ensure good
airflow.
5. Set the
temperature lower
(or higher).
6. (Consult your
dealer or try to use
another heat
appliance.)
This is normal, and
the sound will soon
disappear.
1. Turn off the power
then restart the air
conditioner after a
while.
2. Consult your
dealer.
Outdoor air
temperature
43 °C DB
–10 °C DB
24 °C DB /
18 °C WB
– DB/ –15 °C WB
17

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cs-me18nkeCs-me24nkeCs-me9nkeCs-me12nke

Table of Contents