2-60 PERIODIC MAINTENANCE
Install the pad spring [A] in the caliper as shown.
Apply brake fluid to the outside of the piston [B], and push
it into the cylinder by hand.
Replace the shaft rubber friction boot [C] and dust boot
Install the pad spring [A] on the caliper holder as shown.
Apply a thin coat of PBC (Poly Butyl Cuprysil) grease to
the caliper holder shafts [B] and holder holes (PBC is a
special high temperature, water-resistance grease).
Install the pads (see Rear Brake Pad Installation in the
Wipe up any spilled brake fluid on the caliper with wet
Spark Plug Replacement
Stick Coils (see Stick Coil Removal in the Electrical Sys-
Remove the spark plug using the 16 mm (0.63 in.) plug
wrench [A] vertically.
Owner's Tool - Spark Plug Wrench, 16 mm: 92110-1132
Replace the spark plug with a new one.
Standard Spark Plug
Insert new spark plug in the plug hole, and finger-tighten
Using the plug wrench [A] vertically, tighten the plug.
The insulator of the spark plug may break if when
the wrench is inclined during tightening.
Torque - Spark Plugs: 13 N·m (1.3 kgf·m, 113 in·lb)
Install the stick coils securely.
Be sure the stick coils are installed by pulling up it lightly.