For Secondary Fuel Hose
Set up the fuel tank (see Air Cleaner Element Replace-
Be sure to place a piece of cloth [A] around the fuel hose
Push the joint lock claws [C].
Pull the joint lock [A] as shown.
Pull the fuel hose joint [B] out of the delivery pipe [C].
Be prepared for fuel spillage; any spilled fuel must
be completely wiped up immediately.
When the fuel hose is disconnected, fuel spills out
from the hose and the pipe because of residual
pressure. Cover the hose connection with a piece
of clean cloth to prevent fuel spillage.
Fuel Hose Mounting Screw [A]
Fuel Hose [B]
Apply engine oil to the new O-ring [A].
Torque - Fuel Hose Mounting Screw [B]: 9.9 N·m (0.50
kgf·m, 43 ft·lb)
Insert the fuel hose joint [A] straight onto the delivery pipe
until the hose joint clicks.
Push [B] the joint lock [C] until the hose joint clicks.
Make sure the fuel hose joint is installed correctly
on the delivery pipe or the fuel could leak.
Run the fuel hose in accordance with the Cable, Wire, and
Hose Routing section in the Appendix chapter.
Install the removed parts (see appropriate chapters).
Start the engine and check the fuel hose for leaks.
PERIODIC MAINTENANCE 2-49