16-74 ELECTRICAL SYSTEM
Meter, Gauge, Indicator Unit
Check that the stop watch display has 00' 00" 00 display
[A], And lap No display has water temperature display [B],
when connecting  to (+) terminal again, after discon-
necting it while operating the stop watch.
If the display function does not work, replace the meter
Check 13: Gear Position Indication Inspection
Install the meter unit (see Meter Unit Installation).
Turn the ignition switch ON.
Check that the N mark neutral indicator light (LED) [A]
Set the low gear position, check that the display changes
to 1 mark.
For the other gear position indication;
Using the stand, raise the rear wheel off the ground (see
Interlock Operation Inspection).
Start the engine, change the gear position.
Check that the display corresponding to each gear posi-
tion appears [A].
Turn the ignition switch OFF.
If the display function does not work, go to the Check 1
and check the following items.
Wiring (see Wiring Inspection)
ECU Communication Line Wiring
Gear Position Switch (see Gear Position Switch Inspec-
If the above items are good, replace the meter assembly