Meter, Gauge, Indicator Unit
By pushing the RESET button, check that the hour display
decides and minute display [A] starts flashing.
By pushing the MODE button each time, check that the
minute display changes.
By pushing the RESET button, check that the hour and
minute display start flashing.
By pushing the MODE button, check that the hour and
minute display decide.
When both hour and minute display is flashing, by push-
ing the RESET button, check that the hour display start
flashing. This flashing returns the hour setting display.
If the display function does not work, replace the meter
If the terminal 15 disconnected when the clock is setting,
clock is set at time of that time.
Check 6: Speedometer Inspection
Connect the leads in the same circuit as Check 1.
The speed equivalent to the input frequency is indicated in
the oscillator [A], if the square wave (illustrated as shown)
would be input into the terminal .
Indicates approximately 60 mph in case the input fre-
quency would be approximately 525 Hz.
Indicates approximately 60 km/h in case the input fre-
quency would be approximately 840 Hz.
The input frequency of the oscillator adds the integrated
value of the odometer.
The integrated value of the odometer cannot be reset.
If the oscillator is not available, the speedometer can be
checked as follows.
Install the meter unit.
Raise the rear wheel off the ground, using the stand.
Turn on the ignition switch.
Rotate the rear wheel by hand.
Check that the speedometer shows the speed.
If the speedometer does not work, check the speed sen-
sor electric source voltage and speed sensor.
The electric source voltage and speed sensor are normal,
replace the meter assembly.
ELECTRICAL SYSTEM 16-69