16-38 ELECTRICAL SYSTEM
Pushing the starter button, turn the engine 4 ∼ 5 sec-
onds with the transmission gear in neutral to measure the
crankshaft sensor peak voltage.
Repeat the measurement 5 or more times.
Crankshaft Sensor Peak Voltage
Standard: 3.2 V or more
Special Tools - Hand Tester: 57001-1394
Peak Voltage Adapter: 57001-1415
If the tester reading is not specified one, check the crank-
Stick Coil Removal
Air Cleaner Housing (see Air Cleaner Housing Removal
in the Fuel System (DFI) chapter)
Disconnect the stick coil connectors [A].
Pull the stick coils [B] off the spark plugs.
Do not pry the connector part of the coil while re-
moving the coil.
Stick Coil Installation
Apply grease to the stick coils [A].
Insert the stick coils [B] as shown being careful of the coil
Align the lines [C] of the cylinder head cover and coil head
Be sure the stick coils are installed by pulling up [A] it
Do not tap the coil head while installing the coil.
Connect the connectors.
Run the hoses and harness correctly (see Cable, Wire,
and Hose Routing section in the Appendix chapter).
Install removed parts (see appropriate chapters).