16-26 ELECTRICAL SYSTEM
Charging Condition Inspection
Battery charging condition can be checked by measuring
battery terminal voltage with a digital voltmeter [A].
Fuel Tank (see Fuel Tank Removal in the Fuel System
Battery Cable Caps (see Battery Removal in this chap-
Disconnect the battery terminals.
Be sure to disconnect the negative (–) cable first.
Measure the battery terminal voltage.
Measure with a digital voltmeter which can be read one
decimal place voltage.
If the reading is 12.8 V or more, no refresh charge is re-
quired, however, if the read is below the specified, refresh
charge is required.
Battery Terminal Voltage
12.8 V or more
Terminal Voltage (V) [A]
Battery Charge Rate (%) [B]
Refresh charge is required [D]
Remove the battery [A] (see Battery Removal in this chap-
Do refresh charge by following method according to the
battery terminal voltage.
This battery is sealed type. Never remove sealing
cap [B] even at charging. Never add water. Charge
with current and time as stated below.