Oil Pressure Switch
Oil Pressure Switch Removal
Drain the engine oil (see Engine Oil Change in the Peri-
odic Maintenance chapter).
Remove the right lower fairing (see Lower Fairing Re-
moval in the Frame chapter).
Slide out the rubber boot [A].
Loosen the oil pressure switch terminal bolt [B], and re-
move the switch lead [C].
Remove the oil pressure switch [D].
Oil Pressure Switch Installation
Apply silicone sealant to the threads of the oil pressure
switch [A] and tighten it.
Sealant - Kawasaki Bond (Silicone Sealant): 56019-120
Torque - Oil Pressure Switch: 15 N·m (1.5 kgf·m, 11 ft·lb)
Install the switch lead [B] direction as shown.
Front View [C]
Torque - Oil Pressure Switch Terminal Bolt: Hand-tighten
Apply high-temperature grease to the switch terminal [D].
Slide back the rubber boot to the original position.
Apply a small amount grease to the terminal so that
grease should not close two breather holes [A] for
ENGINE LUBRICATION SYSTEM 7-21