Align the line [A] of the water pump cover and the white
mark [B] of the water hose [C].
Install the water hose clamp [D] as shown.
Torque - Water Hose Clamp Screw: 2.0 N·m (0.20 kgf·m, 17
Fill the engine with engine oil (see Engine Oil Change in
the Periodic Maintenance chapter).
If the oil pump and camshaft or cylinder head were re-
moved as a set, remove the oil cooler/oil filter case and
pour the engine oil into the oil passages of the upper
crankcase (see Oil Cooler/Oil Filter Case Installation).
Fill the engine with coolant and bleed the air from the cool-
ing system (see Coolant Change in the Periodic Mainte-
Oil Pump Gear Removal
Remove the clutch (see Clutch Removal in the Clutch
Fit the suitable tool [A] into the hole of the oil passage plug
Hold the oil pump gear [A] steady with the suitable tool
[B], and remove the bolt [C].
Remove the oil pump gear.
Oil Pump Gear Installation
Align the groove [A] of the oil pump gear to the oil pump
gear shaft [B] to install the oil pump gear.
Apply a non-permanent locking agent to the threads of
the oil pump gear bolt.
Hold the oil pump gear steady with the suitable tool, and
tighten the bolt.
Torque - Oil Pump Gear Bolt: 9.8 N·m (1.0 kgf·m, 87 in·lb)
ENGINE LUBRICATION SYSTEM 7-15