5-40 ENGINE TOP END
Front Exhaust Pipe Installation
Replace the front exhaust pipe gaskets [A] with new ones.
Replace the rear exhaust pipe gasket [B] with a new one.
Install the rear exhaust pipe gasket until it is bottomed so
that the chamfer side [C] faces to the rear exhaust pipe
Install the front exhaust pipe [E].
Touch the gasket stoppers [F] of the rear exhaust pipe to
the end of the gasket.
Install the rear exhaust pipe clamp bolt [G] as shown.
About 6 mm (0.24 in.) [J]
Viewed from Rear [K]
Torque - Front Exhaust Pipe Holder Nuts [L]: 17 N·m (1.7
kgf·m, 13 ft·lb)
Front Exhaust Pipe Mounting Bolt [M]: 28 N·m (2.8
kgf·m, 21 ft·lb)
Rear Exhaust Pipe Clamp Bolt: 17 N·m (1.7 kgf·m,
For the Europe Models, route the oxygen sensor leads
correctly (see Cable, Wire, and Hose Routing section in
the Appendix chapter).
Tighten the radiator lower and upper bolts (see Radiator
and Radiator Fan Installation in the Cooling System chap-
Throughly warm up the engine, wait until the engine cools
down, retighten all the bolt and nuts.