Connect the fuel hose [A] to the fuel supply pipe of the
Special Tool - Fuel Hose: 57001-1607
Secure the fuel hose with a clamp.
Insert the fuel hose into the measuring cylinder [B].
Wipe off spilled out fuel immediately.
Be sure to hold the measuring cylinder vertical.
Close the fuel tank cap.
With the engine stopped, turn the ignition switch ON. The
fuel pump should operate for 3 seconds, and then should
Do not drive the fuel pump 3 seconds or more with-
out the fuel in the fuel tank. If the fuel pump is driven
without the fuel, it may be damaged.
Measure the discharge for 3 seconds.
Repeat this operation several times.
Amount of Fuel Flow
Standard: 67 mL (2.27 US oz) or more for 3 seconds
If the fuel flow is much less than the specified, check the
Battery Condition (see Charging Condition Inspection in
the Electrical System chapter)
After inspection, connect the fuel hoses (see Fuel Tank
Start the engine and check for fuel leakage.
FUEL SYSTEM (DFI) 3-105