34
MW800 CPU Owner's Manual
To reinstall a program, from the Add/Remove Programs Properties window, click
Install, and then follow the instructions on the screen.
Recovering the hard disk to factory contents from recovery CD (only for
Windows 2000)
If your hard disk data is completely damaged and none of above procedures helps,
you can recover the hard disk software image similar to the initial factory install with
the recovery CD.
To recover the hard disk, do the following:
• Turn the CPU off.
• Connect USB CD-ROM drive to your device
• Insert recovery CD into USB CD-ROM drive
• Turn on your computer.
Watch the display carefully. When the M-logo is displayed, press the F2
•
button to enter BIOS setup.
• Make your CD-ROM drive a bootable device as follows: Set the first boot
priority for USB device and exit from BIOS setting with configuration save
and reboot.
• Follow the instructions on the screen:
Press the 'Y' key when "Copy disk image from CD to hard disk.
Continue?" appears on the screen.
Type the word "agree" and press Enter when "This will erase all data...
type agree to confirm this action" appears on the screen.
• Wait until copying is finished.
• Disconnect the USB device from the MW800 and reboot again
When the recovery process finishes, your computer will restart with the pre-installed
operating system, drivers, and software. If automatic restart is not performed, restart
the system by pressing Ctrl + Alt + Del or by turning the computer off and then on.
Hard Drive Replacement
Replace the hard disk only if it needs to be repaired (if none of the aforementioned
procedures are effective). Understand that the hard disk bay connector was not
designed for frequent connections and could be damaged through improper use.