Searchcoil Replacement - AKA SOREX PRO Operating Manual

slightly aside from the assumed target location and press
Warning! Avoid turning this mode on in the zone of target sensitivity (put the coil
rather far aside).
Then smoothly pass it above the detected target, keeping constant distance
from the ground. Sound signal volume and frequency will increase upon approaching the
target, decrease upon moving away. Frequency and volume "peak" will be noticed at the
centre of the target respectively. To finish centre clarification make two perpendicular
passes. Signal "peak" cross, right under the centre of the coil is a target centre.
At the same time, target centre clarification may be visually controlled on the
screen of your device. Onscreen scale cells will be filled when approaching the target
centre and brighten when moving away from the centre. Target centre corresponds to
the fully filled onscreen scale. Use buttons
sensitivity.
If the signal is too strong and continuous, the target is large and relatively close
to the surface. Raise the coil to the level where the target is less responsive and you will
be able to detect target contour in the ground by crisscrossed passes.
To exit the mode press

Searchcoil replacement.

Changes of search conditions may require replacement of a searchcoil with
another searchcoil of different size and operating frequency. For example, moving from
relatively clear zone to the trashy zone. The search goal may also be changed: from large
to small objects. Such change increases operating frequency. Unlike other models of the
line, Sorex PRO has built-in systems of automatic and semi-automatic (forced) adaptation
of the searchcoil..
The automatic searchcoil replacement system detects change of the converter
operating frequency and initiates adaptation process which includes selection of a new
frequency and preparation of the electronic module hardware for the operation in
changed frequency conditions.
The automatic system is performing well for recurrent replacement of
searchcoils with different frequencies.
However, if you replace searchcoils with different sizes working on the same
frequency we recommend you to use semi-automatic adaptation system. Operating
frequencies may vary because of the technical parameter spread, but it does not mean
that the automatic system would be started. The spread of technical parameters of the
searchcoil may decrease sensitivity and make VDI numbers incorrect. The semi-automatic
system avoids these errors. This system is useful for the correction of the influence of
AKA LLC +7(495)623-4026 621-0481 http://aka.2000.ru aka_md@mail.ru
Selective Metal Detector SOREX PRO. Operating manual.
one more time.
.
to adjust static mode
and
23