Download  Print this page

Card Reader Configuration - Siemens AR6181-MX Installation And Configuration Manual

Hide thumbs

Advertisement

Card reader configuration

9
Card reader configuration
9 V power
adapter
24
Siemens Building Technologies
Fire & Security Products
The configuration of the card reader is performed with the ConfigCard or the serial
RS485 interface and a terminal program. For more information please refer to
chapter 9.2 Launching the terminal program. The ConfigCard is a proximity ID card
(Mifare) which is written with the help of the ConfigCard Creation Tool (optional
software) and the parameters. The parameters from the ConfigCard can be read
from the AR618x-MX after a power-up.
Requirement
To run the terminal program with AR618x-MX you have to connect the reader to
your PC. Use serial communication line COM1/2, a converter RS485/232 and a
connecting cable.
RS485/RS232
Power supply
B
A
adapter
The special configuration mode can be reached with the following DIP settings. In
this position no cards will be read or any card information transmitted.
DIP 1, DIP 2, DIP 3, DIP 4 = off or on
DIP 5, DIP 6 = on
DIP 7, DIP 8 = off or on
Within configuration mode you may check or change some additional settings or
get information out of the reader with a terminal program, e.g. HyperTerminal. For
more information please refer to chapters 9.2 and 9.3.
RS232
1:1 cable
R/A
AR6181-MX
T/B
12 V-
Wall power supply plug
power
COM1
PC
Mains power supply
Terminal 1 + 12 V
Terminal 2 GND
12.2004

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ar6182-mx