Download  Print this page

Surface Mounting - Siemens AR6181-MX Installation And Configuration Manual

Hide thumbs

Advertisement

Installation
6.3

Surface mounting

10
Siemens Building Technologies
Fire & Security Products
The unit should be installed on a surface that is as even as possible.
Create openings for the lead in the distance frame and pull the lead through.
Screw the distance frame onto the base.
Procedure
Slot the connection board into the bottom section of the housing with the
terminals facing downwards. To do this gently push the locating hooks apart with
your fingers.
Connect the cable to the terminal strip in the bottom section of the housing
(see chapter „5.1 Connecting the reader").
Plug the top section onto the bottom section of the housing. In doing so, insert
the male connector of the reader electronics cleanly into socket connector X3 on
the terminal board!
Do not mount the unit to the wall before you have checked the set-up
works.
Remove the top section of the housing from the bottom section.
Screw the bottom section of the housing incl. the snapped terminal board onto
the distance frame using 3 x 16 mm self-tapping screws.
Plug the top section onto the bottom section of the housing. In doing so, insert
the male connector of the reader electronics cleanly into socket connector X3 on
the terminal board!
Screw in the safety screw on the underneath of the bottom section of the
housing.
Mounting in conformity with IP 65
In order to mount the reader, regarding the IP 65 conditions, the following
instructions are to be followed.
Three special gaskets are enclosed in the reader package.
Gasket 1
(one-sided self-adhesive)
Fig. 4
Three gaskets in the reader package
Usage
Gasket 1:
Between reader and mounting surface, with or without distance frame
Gasket 2:
Between housing base and distance frame
Gasket 3:
Gasket for safety screw
Gasket 2
(one-sided self-adhesive)
Gasket 3
12.2004

Advertisement

This manual also for:

Ar6182-mx

Comments to this Manuals

Symbols: 0
Latest comments: