16-14 ELECTRICAL SYSTEM
Using a high-flash point solvent, clean off any oil or dirt
that may be on the crankshaft taper [A] or in the hole [B]
of the flywheel. Dry them with a clean cloth.
Fit the woodruff key [C] securely in the slot of the crank-
Install the flywheel according to the following procedures.
Confirm the flywheel fit or not to the crankshaft before
tightening it with specified torque.
Install the flywheel and tighten the flywheel nut with 54
N·m (5.5 kgf·m, 40 ft·lb) of torque.
Remove the flywheel nut.
Check the tightening torque with rotor puller.
If the flywheel is not pulled out with 20 N·m (2 kgf·m, 15
ft·lb) of drawing torque, it is installed correctly.
If the flywheel is pulled out with under 20 N·m (2 kgf·m,
15 ft·lb) of drawing torque, clean off any oil dirt or flaw of
the crankshaft and flywheel tapered portion, and dry them
with a clean cloth. Then, confirm that it is not pulled out
with above torque.
Hold the flywheel steady with the rotor holder, and tighten
the flywheel nut.
Special Tool - Rotor Holder: 57001-1730
Torque - Flywheel Nut: 78 N·m (8.0 kgf·m, 58 ft·lb)
Install the magneto cover (see Magneto Cover Installa-
Stator Coil Removal
Magneto Cover (see Magneto Cover Removal)
Stator Coil Bolts [A]
Crankshaft Sensor Bolts [B]
Wiring Holder [C]
Wiring Grommet [D]
Remove the stator coil [E] and crankshaft sensor [F] as a