Remove the screws [A]
Remove the chain slipper [B] from the swingarm.
Apply plenty of grease to the inside of the needle bear-
ings, sleeves, and grease seals.
Install the collars to the both sides of the swingarm.
Torque - Swingarm Pivot Shaft Nut: 98 N·m (10 kgf·m, 72
Rocker Arm Pivot Nut: 59 N·m (6.0 kgf·m, 44 ft·lb)
Install removed parts (see appropriate chapters).
Swingarm Bearing Removal
Swingarm (see Swingarm Removal)
Grease Seals [B]
Needle Bearings [D]
Remove the needle bearings [E] using the oil seal & bear-
Special Tool - Oil Seal & Bearing Remover: 57001-1058
Swingarm Bearing Installation
Replace the needle bearings and, grease seals with new
Install the needle bearings [A] [B] and grease seals [C]
position as shown.
Special Tool - Bearing Driver Set: 57001-1129
Install the needle bearings so that the manufacturer's
marks face out.
Install the grease seals so that the deep groove side of
the rip in-ward.
The installation procedure is the same as the counter
[D] 1.5 mm (0.059 in.)
[E] 1 mm (0.039 in.)