Repeat this operation until no more air can be seen com-
ing out into the plastic hose.
1. Pump the brake lever until it becomes hard, and apply
the brake and hold it [A].
2. Quickly open and close the bleed valve while holding the
brake applied [B].
3. Release the brake [C].
Remove the clear plastic hose.
Tighten the bleed valves, and install the rubber caps.
Torque - Caliper Bleed Valve: 7.8 N·m (0.80 kgf·m, 69 in·lb)
Hold the master cylinder horizontally, and check the fluid
level in the reservoir.
After bleeding is done, check the brake for good braking
power, no brake drag, and no fluid leakage.
Do not attempt to drive the motorcycle until a full
brake lever or pedal is obtained by pumping the
brake lever or pedal until the pads are against the
disc. The brake will not function on the first appli-
cation of the lever or pedal if this in not done.