Fit the projection [A] on the cap to the groove [B] on the
The collars are identical.
Apply grease to the grease seal lips of the rear hub.
Fit the collars [A] and caps [B] on the both sides of the
Engage the joint of the drive chain, and install the master
link from the inside.
Install the master link clip [A] so that the closed end [B] of
the "U" points in the direction of chain rotation [C].
Check the drive chain slack (see Drive Chain Slack in-
spection the Periodic Maintenance chapter).
Torque - Rear Axle Nut: 110 N·m (11.2 kg·m, 81.1 ft·lb)
Install the new cotter pin [A] and spread its end.