Front Wheel Removal
Unscrew the axle nut [A].
Loosen the left and right axle clamp bolts [B].
Using the jack under the frame, and raise the front wheel
off the ground.
Special Tool - Jack: 57001-1238
Apply the rear brake to rear wheel so that it does not turn.
Remove the axle [C], and pull out the wheel. Take off the
collars and caps [D] from both side of the front hub.
Do not lay the wheel on the ground with the disc
facing down. This can damage or warp the disc.
Place blocks under the wheel so the disc does not
touch the ground.
Insert a wood wedge between the disc brake pads this
prevents them from being moved out of their proper posi-
tion, should the brake lever be squeezed accidentally.
Front Wheel Installation
Fit the projection [A] on the cap to the groove [B] on the
Apply grease to the grease seal lips of the front hub.
Install the collars [A] and caps [B] on the left and right side
of the hub.
Insert the axle [A] from right side until it stops at the bot-
Tighten the right axle clamp bolts [B] temporally.