Balancer Drive Gear [B]
Remove the crankcase bolts [A].
Pry a pry point [A] at the crankcase mating surface, and
split the crankcase.
If crankcase splitting can not easily, split the crankcase
according to the following procedures.
Install the jig [A] between the crankshaft flywheels.
Special Tool - Crankshaft Jig: 57001-1174
Attach the crankcase splitting tool [B] to the left crankcase
Special Tool - Crankcase Splitting Tool Assembly: 57001
Tighten the center bolt of the crankcase splitting tool to
split the crankcase halves.
Oil Screen (Feed) [A] (see Oil Screen (Feed) Removal
in the Engine Lubrication System chapter)
Shift Rods [B] (see Transmission Shaft Removal)
Shift Forks [C] (see Transmission Shaft Removal)
Shift Drum [D] (see Transmission Shaft Removal)
Transmission [E] (see Transmission Shaft Removal)
Remove the crankshaft [F] from the right crankcase half
(see Crankshaft Removal).