8-6 ENGINE REMOVAL/INSTALLATION
Water Hoses [A]
Right Engine Guard [B]
Remove the bolts [C], and remove the brake pedal [D]
and rear master cylinder [E] as a set.
Upper Engine Bracket Bolts (Left and Right) [A]
Upper Engine Mounting Bolts and Nuts (Left and Right)
Upper Engine Brackets (Left and Right) [C]
Middle Engine Bracket Bolts and Nuts [D]
Middle Engine Mounting Bolt and Nut [E]
Middle Engine Brackets (Left and Right) [F]
Lower Engine Mounting Bolt and Nut [G]
Remove the swingarm pivot shaft nut [A] to pull out the
swingarm pivot shaft [B].
Pull out the swingarm pivot shaft half way from right side
to free the engine.
Disconnect the water temperature sensor connector [C].
Remove the engine from the vehicle to right side.
Clear the engine rear portion from the swingarm and then
remove the engine.