Install the clutch spring plate [A].
Torque - Clutch Spring Bolts [B]: 8.8 N·m (0.90 kgf·m, 78
Install the clutch cover (see Clutch Cover Installation).
Check the release shaft lever positions.
Pushing [B] the release shaft lever [C] lightly forward,
measure the distance [A] between the lever and cable
Release Shaft Lever Position
68.6 ∼ 76.4 mm (2.70 ∼ 3.01 in.)
If the lever position is not within the standard, select the
correct thickness of adjusting washer(s) according to the
Release Shaft Lever Position and Adjusting Washer
68.6 mm to 76.4 mm
More than 76.4 mm
Less than 68.6 mm
If the replacement of the adjusting washer is necessary,
remove the clutch spring plate again and install the se-
lected washer [A]