Check the clutch plate assembly free play (see Clutch
Plate Assembly Free Play Inspection/Adjustment).
Apply molybdenum disulfide oil to the inside of the clutch
Clutch Housing [A]
Toothed Washer [B]
Install the clutch hub [A].
Install the washer so that stamp mark [B] facing the out-
Tighten the clutch hub nut [A] using the clutch holder [B].
Special Tool - Clutch Holder: 57001-1243
Torque - Clutch Hub Nut: 98 N·m (10 kgf·m, 72 ft·lb)
Install the friction plates and steel plates, starting with a
friction plate [A] and alternating them. Finishing with a
Install the friction plates which the lining blocks [B] on the
plates installed to both end are more than the one of the
If dry steel plates and friction plates are installed,
apply engine oil to the surfaces of each plate to
avoid clutch plate seizure.
Apply molybdenum disulfide grease to the sliding portion
[A] of the push rod holder.
Install the push rod [B] and push rod holder.
Apply molybdenum disulfide grease to the needle bearing
[C] and washer [D], and install them.