Hammer lightly on the valve guide arbor [A] to remove the
Special Tool - Valve Guide Arbor, 5.5: 57001-1021
Valve Guide Installation
Apply a thin coat of oil to the outer surface of the valve
Heat the area around the valve guide up to 120 ∼ 150°C
(248 ∼ 302°F).
Do not heat the cylinder head with a torch. This will
warp the cylinder head. Soak the cylinder head and
heat the oil.
Assemble the valve guide driver [A] and valve guide driver
attachment G [B].
When install the exhaust valve guide, using the attached
washer (t = 2.0) [C] of the attachment D.
Special Tools - Valve Guide Driver: 57001-1564
Valve Guide Driver Attachment D: 57001
Valve Guide Driver Attachment G: 57001
Using the valve guide driver, press and insert the valve
guide in until the valve guide driver surface [D] touches
the head surface.
[E] Exhaust 11.35 ∼ 11.55 mm (0.437 ∼ 0.445 in.)
[F] Inlet 13.35 ∼ 13.55 mm (0.516 ∼ 0.524 in.)
Ream the valve guide with valve guide reamer [A], even
if the old guide is reused.
Special Tool - Valve Guide Reamer, 5.5: 57001-1079
ENGINE TOP END 5-25