3-88 FUEL SYSTEM (DFI)
Be sure to place a piece of cloth around the fuel hose joint
Insert a minus screw driver [B] into the slit on the joint lock
Turn the driver to disconnect the joint look.
Pull [B] the fuel hose joint [A] out of the fuel outlet pipe.
Be prepared for fuel spillage; any spilled fuel must
be completely wiped up immediately.
When the fuel hose is disconnected, fuel spills out
from the hose and the pipe because of residual
pressure. Cover the hose connection with a piece
of clean cloth to prevent fuel spillage.
Close the fuel tank cap.
Remove the fuel tank with the radiator shroud, and place
a it on a flat surface.
Do not apply the load to the fuel outlet pipe of the fuel
Store the fuel tank in an area which is well
-ventilated and free from any source of flame
or sparks. Do not smoke in this area. Place the
fuel tank on a flat surface and plug the fuel pipes
to prevent fuel leakage.
Fuel Tank Installation
Note the above WARNING (see Fuel Tank Removal).
Route the hoses correctly (see Cable, Wire, and Hose
Routing in the Appendix chapter).
Check that the dampers [A] are in place on the frame.
If the dampers are damaged or deteriorated, replace it.