Throttle Grip and Cable
Loosen the mounting bolts [A].
Remove the cables [B] from the throttle body assy.
Free the tips [C] from the pulley.
Pull out the cables from the frame.
Lubricate the cable.
Apply grease to the tips of the cables.
Install the throttle cable tips [A].
Install the mounting bolts [B] to the holder as shown.
Install the throttle pulley cover.
Torque - Throttle Cable Mounting Bolts:
kgf·m, 62 in·lb)
Throttle Pulley Cover Bolt: 7.0 N·m (0.71 kgf·m, 62
Install the removed parts (see appropriate chapters).
Install the throttle cable in accordance with the Cable,
Wire, and Hose Routing section in the Appendix chapter.
After the installation, adjust each cable properly.
Operation with an incorrectly routed or improperly
adjusted cable could result in an unsafe riding con-
Throttle Cable Lubrication
Whenever the throttle cable is removed or in accordance
with the Periodic Maintenance Chart, lubricate the these
cables (see Lubrication in the Periodic Maintenance
Apply a thin coating of grease to the cable upper end.
Use a commercially available pressure cable lubricator to
lubricate these cables.
Throttle Cable Inspection
Refer to the Cable Inspection in the Periodic Maintenance
7.0 N·m (0.71
FUEL SYSTEM (DFI) 3-81