3-76 FUEL SYSTEM (DFI)
Fuel Pressure Inspection
Be sure the battery is fully charged.
Left Radiator Shroud (see Radiator Shroud Removal in
the Frame chapter)
Fuel Tank (see Fuel Tank Removal)
Fuel Hose (see Fuel Injector Removal)
Be sure to place a piece of cloth around the fuel outlet
pipe of the fuel pump and the delivery pipe of the throttle
Be prepared for fuel spillage; any spilled fuel must
be completely wiped up immediately.
When the fuel hose is disconnected, fuel spills out
from the hose and the pipe because of residual
pressure. Cover the hose connection with a piece
of clean cloth to prevent fuel spillage.
Install the fuel pressure gauge adapter [A] and fuel hoses
(Special Tool: 57001-1607) [B] between the fuel outlet
pipe and delivery pipe.
Secure the fuel hoses with the clamps.
Connect the pressure gauge [C] to the fuel pressure
Special Tools - Oil Pressure Gauge, 5 kgf/cm²: 57001-125
Fuel Pressure Gauge Adapter: 57001-1593
Fuel Hose: 57001-1607
Do not try to start the engine with the fuel hoses
Fuel Pump Lead Connector
Capacitor Lead Connector [A]