Remote Access Code; Message Alert Tone - AT&T EL52200 User Manual

Dect 6.0 cordless telephone/answering system with caller id/call waiting
Hide thumbs Also See for EL52200:
Table of Contents

Advertisement

Answering system settings
Answering system settings
5.
Press
or
DIR
Toll saver- the answering system answers a call after two rings when
you have new messages, and after four rings when there are no new
messages. This feature allows you to check for new messages and avoid
paying long distance charges if you are calling from out of your local area.
6.
Press
/SELECT to confirm your setting. There is a confirmation tone.
mEnU
note: If you subscribe to a voicemail service offered through your telephone service
provider, see Answering system and voicemail on page 43.

Remote access code

To access your answering system remotely from any touch-
tone telephone, you need to enter a two-digit number (00-
99). Unless you change it, the remote access code is 19.
To change the remote access code:
1.
Follow Steps 1-3 in number of rings on page 41.
2.
Press
or
DIR
3.
Press
or
DIR
keys to enter the correct number (00-99).
4.
Press
/SELECT to confirm your setting. There is a confirmation tone.
mEnU
note: For more details about the remote access feature, refer to Remote access on page 51.

message alert tone

When the message alert tone is set to on, and there is at least one new
message, the telephone base beeps every 10 seconds. Unless you change it,
the message alert tone is set to off.
To change the setting:
Follow Steps 1-3 in number of rings on page 41.
1.
2.
Press
or
DIR
/SELECT.
press
mEnU
3.
Press
or
DIR
/SELECT to confirm your setting. There is a confirmation tone.
4.
Press
mEnU
notes:
The message alert tone beeps only if all the following conditions are met:
– Answering system is on.
– Message alert tone is on.
– There are new messages.
To temporarily turn off the message alert tone, see Temporarily turning off the message
alert tone on page 45.
to scroll and choose among 2, 4, 6 or ToLL SAvER.
CID
to scroll to >REmoTE CoDE, then press
CID
to select the remote access code, or use the dial pad
CID
to scroll to >mSG ALERT TonE, then
CID
to choose on or oFF.
CID
42
REMOTE CODE
19
/SELECT.
mEnU
MSG ALERT TONE
>OFF

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents