Electrical Connection - Miele H 4846 BP Installation Instructions Manual

Hide thumbs


CAUTION: Before servicing,
disconnect the power supply by
either removing the fuse, shutting off
the power main or manually
"tripping" the circuit breaker.
Installation work and repairs should
only be performed by a qualified
technician in accordance with all
applicable codes and standards.
Repairs and service by unqualified
persons could be dangerous and
the manufacturer will not be held
Before connecting the appliance to
the power supply, make sure that
the voltage and frequency listed on
the data plate correspond with the
household electrical supply. This
data must correspond to prevent
machine damage. Consult an
electrician if in doubt.
Only operate the appliance after it
has been installed into cabinetry.
Please leave these instructions with
the consumer.

Electrical connection

Power supply
The oven is equipped with a 6 ft.
(1.8 m) flexible power cord consisting
of 4 wires ready for connection to a
dedicated 3 pole, 4 wire grounded
power supply:
120/240 V, 60 Hz, 30 A fuse rating
120/208 V, 60 Hz, 30 A fuse rating
Black wire: connect to L1 (hot)
Red wire:
connect to L2 (hot)
White wire: connect to N (neutral)
Green wire: connect to GND (ground)
A dedicated line and junction box
should be used to connect the oven to
a 30 A circuit.
Connection details are also given on the
diagram located on the top of the oven.
Data plate
The silver data plate is located along
the front side of the oven with the door



This manual is also suitable for:

H 4844 bp

Table of Contents