Motorola VT1000 User Manual: Installation With A Single Computer

Motorola user guide voice terminal vt1000 series.
Hide thumbs
Broadband
Modem
Ethernet port
WAN
Motorola voice
terminal
LINE 1
Phone
12

Installation With A Single Computer

To connect your Motorola voice terminal as shown in
Home
1
2
3
PC
4
Ethernet port
5
Computer
6
Network" on page 2:
Be sure the Motorola voice terminal is unplugged. Be sure power is off to your
broadband modem (cable or DSL) and computer.
Connect one end of an Ethernet cable (RJ-45) to the Ethernet connector on your
broadband modem. Connect the other end of this Ethernet cable to the WAN
connector on the Motorola voice terminal.
Connect one end of another Ethernet cable to the PC connector on the Motorola
voice terminal. Connect the other end of this Ethernet cable to the Ethernet
connector on the computer.
Connect a telephone to the LINE 1 connector using a phone wire (RJ-11). For a VT1005
or VT1005v only, you can connect a second telephone to the LINE 2 connector.
Power on the broadband modem, following the instructions provided with your
modem. Wait about two minutes for it to start up.
Plug the AC power adapter to the POWER connector on your Motorola voice
terminal and the electrical outlet. This turns your Motorola voice terminal on. You do
not need to unplug it when not in use.
Wait about two minutes for the Motorola voice terminal to start up. The POWER light
blinks as described in
"Front
"Sample Configuration Without A
Panel" on page 7.

Advertising

   Related Manuals for Motorola VT1000

This manual also for:

Vt1003, Vt1005, Vt1003v, Vt1005v

Comments to this Manuals

Symbols: 0
Latest comments: