Connecting An Antenna Or Cable Tv (No Box) - Toshiba 65L350U Instruction Manual

65L350U Toshiba 65" 1080p 120Hz LED TV

Connecting an antenna or cable TV (no box)

Antenna or cable TV
On your TV
Coaxial cable
connector
ANT / CABLE IN
jack
1 Make sure that your TV's power cord is unplugged and all connected equipment is turned off.
2 Connect a coaxial cable (not provided) to the ANT / CABLE IN jack on the back of your TV and to the antenna or
cable TV wall jack.
3 Plug your TV's power cord into a power outlet, then turn on your TV.
4 Press INPUT to open the Input Selection list.
5 Press or to highlight ANT / CABLE, then press ENTER.
6 If you cannot tune to channels you know exist, scan for channels. See
page 55.
Notes
• Use a coaxial cable to eliminate interference and noise from radio waves.
• Do not bundle the coaxial cable with the power cord or other cables.
• If the antenna is not installed correctly, contact qualified service personnel to correct the
problem.
• If the signal level for a channel is weak, the picture may be distorted. Adjust the antenna
or use a highly directional outdoor or set-top antenna with a built-in amplifier.
• If the picture quality is good on some channels and poor on others, the problem may be
caused by a poor or weak signal from the broadcaster or cable TV provider.
• If you connect to cable TV without a set-top box and experience poor picture quality, you
may need to install a set-top box to improve signal reception and picture quality. Contact
your cable TV provider about upgrading to a set-top box.
• Many high-definition (HD) channels upscale standard-definition (SD) content. The picture
displayed on your TV is still displayed as SD, thus the picture quality will not be as clear or
crisp as it would be if the content was originally recorded in HD.
(no box)
Coaxial cable
www.tv.toshiba.com
Back of TV
Automatically scanning for channels on
19