Turning On Cooling and Viewing Set Points
The factory recommended set points are 0°F (-18°C) for the
freezer and 37°F (3°C) for the refrigerator
1. Press the FRIDGE or FREEZER touch pad.
NOTE: After the refrigerator is turned on, the Over
Temperature audio alarm and indicator light may activate
every 1¹⁄₂ hours until the refrigerator and freezer temperatures
are below 48°F (9°C) and 15°F (-9°C), respectively, or until the
alarm is turned off. To turn off the audio alarm and indicator
light, see “Alarm Reset.”
Turning Off Cooling
1. Press the FRIDGE or FREEZER touch pad.
2. Press and hold the COOLING OFF touch pad for 3 seconds.
NOTE: To turn off the power completely, use the power ON/
OFF switch located behind the top grille. See “Power On/Off
Switch.”
Viewing the Temperature in Degrees Celsius
1. Press °C touch pad. To display degrees Fahrenheit, press °F
touch pad.
NOTE: If the freezer temperature is below zero, the negative
sign next to the freezer display will light up. This is normal.
Adjusting Controls
NOTE: Wait at least 24 hours between adjustments. Recheck the
temperatures before other adjustments are made.
To Adjust Set Point Temperatures:
Press the FRIDGE or FREEZER touch pad, and then press the
Plus (+) or Minus (-) touch pad until the desired temperature is
reached.
Press the SAVE touch pad to program the desired
temperature.
NOTE: The set point range for the freezer is -5°F to 3°F
(-21°C to -16°C). The set point range for the refrigerator is 34°F to
42°F (1°C to 6°C).
CONDITION/REASON:
TEMPERATURE
ADJUSTMENT:
REFRIGERATOR too cold
REFRIGERATOR Control 1°
higher
Not set correctly for conditions
REFRIGERATOR too warm
REFRIGERATOR Control 1°
lower
High use or room very warm
FREEZER too cold
FREEZER Control 1° higher
Not set correctly for conditions
FREEZER too warm/too little
FREEZER Control 1° lower
ice
High use or heavy ice use
Page 6