Owner Unit Power Supply - Motorola SCOUT1000 User Manual

2.3

Owner Unit Power Supply

IMPORTANT
Installing the rechargeable battery pack and charging it fully before use is
recommended. This will allow the unit to operate on battery in the event
of a power failure.
1. Connect the small plug of the power adapter to the owner unit and
the other end to the electrical outlet. Only use the enclosed power
adapter (6V DC/500mA).
2. Press and hold the
turn ON the owner unit.
3. Once the pet and owner units are switched on, the display on the
owner unit will show the video captured by the pet unit.
4. If there is no connection or you are out of range, the video display
will go off and
beep every 5 seconds. Move the owner unit closer to the pet unit
until the link is re-established.
5. Press and hold the
bar finishes scrolling, to turn OFF the owner unit.
NOTE
The battery icon
gives a beep every 16 seconds. The battery needs to be recharged. The
battery pack takes about 16 hours to charge fully.
When charging
1. During power OFF, when adapter is plugged in, an adapter logo will
display on screen and then a flashing battery logo will display for 45 sec.
The Blue LED at top left corner light up indicates adapter is plugged in.
Getting Started
POWER ON/OFF button for 1 second to
P
will be shown on the LCD display, and the unit will
POWER ON/OFF button, until the progress
P
turns RED to indicate that the battery is low, and it
9