Prevention Of Afterimage Burn-In - Samsung ME32C User Manual

Prevention of Afterimage Burn-in

Black Matrix
Common
Electrode (ITO)
Source Drain
Gate
TFT
Data Bus-Line
What is afterimage burn-in?
Afterimage burn-in should not occur when the LCD panel is operating normally. Normal operation refers to a continuously
changing video pattern. If the LCD panel displays a fixed pattern for an extended period of time (more than 12 hours), a slight
Color-Filter
voltage difference may occur between the electrodes in pixels that control the liquid crystals.
Such a voltage difference between electrodes increases with time and makes the liquid crystals thinner. When this occurs,
a previous image can remain on the screen when the pattern changes. To prevent this, the accumulated voltage difference
should be reduced.
• Afterimage burn-in should not occur when an LCD panel is operating in proper conditions.
Preventing afterimage burn-in
― The best way to protect the product from afterimage burn-in is switching the power off or setting the PC or system to run a
screen saver when not in use. Also, Warranty service may be limited depending on instruction guide.
• Powering Off, Screen Saver and Power Saving Mode
Storage
Pixel Electrode (ITO)
Capaccitor (Cs)
• Regular color Change
FLIGHT
- Power off the product for 4 hours after using it for 20 hours.
- Power off the product for 2 hours after using it for 12 hours.
- Go to Display Properties > Power Supply on your PC and set the product to power off as required.
- Using a screen saver is recommended.
It is best to use a single-color or moving-image screen saver.
- Use 2 colors
Switch between 2 colors every 30 minutes as shown above.
Type 1
TIME
OZ348 20:30
UA102 21:10
Type 2
FLIGHT TIME
OZ348 20:30
UA102 21:10
241