Resetting Your Phone; Default Settings; Network Services; Caller Id - Motorola DIGITAL CORDLESS PHONE D210 User Manual

Allegro_CID TAD.book Page 22 Tuesday, January 15, 2008 4:30 PM
4. Press or to select the base number.
Press .

Resetting your phone

If you reset your phone, both the base and handset will return
to their pre-set (default) settings. If you have more than one
handset registered to your base and you complete the
following procedure, only the handset you reset and the base
will go back to the default settings.
For the base:
1. Press to access the main menu.
to select "BS SETTINGS" and press
2. Press or
to select "BS DEFAULT" and press
3. Press or
4. "PIN ?" appears. Enter your PIN code. Press
The base will reset and the handset will return to standby
mode.
For the handset:
1. Press to access the main menu.
to select "HS SETTINGS" and press
2. Press or
to select "HS DEFAULT" and press
3. Press or
4. "PIN ?" appears. Enter your PIN code. Press
The handset will reset and the handset returns to the standby.

12. Default settings

Ringer Volume 2
22
Earpiece Volume 3
Speaker Volume
Base Ringer Type
Alarm
Tone
Auto Answer
Language
Dial Mode
Flash Time
Base PIN
.
Answering Machine
.
Answer ON/OFF
.
Message Alert
Ring delay
Remote operation PIN 0000
Guidance Language

13. Network services

.
To use caller ID or any other services detailed in this section,
.
you must first contact your network provider and subscribe to
the relevant service.
.

Caller ID

With caller ID the caller's number is shown in the handset
display as you receive an incoming call so you can see who is
calling before you pick up the phone.
3
1
OFF
Key Tone ON
Battery Low ON
Range Alarm ON
ON
ENGLISH
TONE
SHORT
0000
ON
ON
4 rings
English