Yamaha 2004 YXR660 Service Manual page 95

CHANGING THE COOLANT
CAUTION:
• Adding water instead of coolant lowers
the antifreeze content of the coolant. If
water is used instead of coolant, check,
and if necessary, correct the antifreeze
concentration of the coolant.
• Use only distilled water. However, soft
water may be used if distilled water is not
available.
• If coolant comes into contact with painted
surfaces, immediately wash them with
water.
• Do not mix different types of antifreeze.
17.Install:
• air bleed bolt
18.Install:
• radiator cap
19.Fill:
• coolant reservoir
(with the recommended coolant to the maxi-
mum level mark a)
20.Install:
• coolant reservoir cap
21.Start the engine, warm it up for several min-
utes, and then turn it off.
22.Check:
• coolant level
Refer to "CHECKING THE COOLANT
LEVEL".
NOTE:
Before checking the coolant level, wait a few
minutes until the coolant has settled.
23.Close the hood.
24.Install:
• console
• passenger seat
• driver seat
Refer to "SEATS, ENCLOSURE, HOOD
AND CARGO BED" in chapter 8.
3 - 22
CHK
ADJ
· ·
9 Nm (0.9 m kg, 6.5 ft lb)