Setup Steps - Ergotron WorkFit-P User Manual

Set-up Steps
1
Warning: Because mounting surface materials can vary widely, it is imperative that you make
sure mounting surface is strong enough to handle mounted product and equipment.
DESK THICKNESS
0.78"-1.38" (20-35mm)
8mm
4 of 8
CLAMP
4 mm
1.18"-2.56" (30-65mm)
GROMMET
a
c
1x
1x
d
1x
1x
CAUTION: Bolt must be centered in hole.
PRECAUCIÓN: El pasador tiene que estar centrado en el orifi cio.
ATTENTION : Le boulon doit être centré dans le trou.
VORSICHT: Die Schraube muss mittig angebracht werden.
WAARSCHUWING: De bout moet in het gat gecentreerd worden.
ATTENZIONE: il bullone deve essere centrato nel foro.
VAR AKTSAM: Bulten måste vara centrerad i hålet.
注意：ボルトは穴の中央に位置する必要があります。
小心：螺栓必须在孔内居中。
4 mm
b
4 mm
888-45-300-G-00 rev. C • 11/13